Any electrical engineers or electronics people out there? I was on the treadmill last week, running at 15km/hr and the treadmill stopped dead. Turns outt the little built-in fuse/GFCI blew and the machine stopped. After a thorough inspection and clean out I determined that static electricity was the cause. So, I grounded the machine and started wearing difference shoes but I’m still spooked to run too fast. Any way to jump the fuse/GFCI? It’s not a super powerful motor or a super nice tread so if it gets fried eventually, I’m ok with that. I’m more ok with that than getting thrown off the tread again. Any advice?